← All recalls
SteeringCA2006306

Itasca SUNCRUISER

Itasca SUNCRUISER

Published
2006-11-14
Model years
2006–2007

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.

View the official source notice →

Itasca SUNOVA

Published
2006-11-14
Model years
2006–2007

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.

View the official source notice →

Itasca SUNRISE

Published
2006-11-14
Model years
2006–2007

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.

View the official source notice →

Winnebago ADVENTURER

Published
2006-11-14
Model years
2006–2007

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.

View the official source notice →

Winnebago SIGHTSEER

Published
2006-11-14
Model years
2006–2007

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.

View the official source notice →

Winnebago VOYAGE

Published
2006-11-14
Model years
2006–2007

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.

View the official source notice →